Replaent Accessories

Standard screw set

Part code: 
HFRSS

Gasoline screw set

Part code: 
HFRGSS

Tool set

Part code:
HFRTOOL

Pack containing - Tool Set, Screw set & Weight hanger cord

Part code:
HFRTSW

Weight Hanger cord

Part code:
HFRWHC

Upper and Lower Specimen Holders

Weight Set

Part code: HFRWT

Main Temperature Probe

Part code: HFRMRTD

Push Rod Insert

Part code: HFRPRI

Heater Block

Part code: HFRHB

Alarm RTD

Part code: HFRARTD

Heaters

Part code: HFRHEAT15

HFRR Humidity and Temperature probe including cable & bracket

Part code: HFRHYG

1. Overview

2. Important Information

3. Verification

Overview

HFRR Connecting Cable and Humidity/Temperature Probe

An optional combined humidity and temperature probe can be connected to the rear of the HFRR control unit. For some test procedures the wear scar must be adjusted to compensate for the effect of fuel moisture content on the result. The probe will automatically measure the ambient temperature and humidity at the start and end of the test, instead of the user having to make the measurements manually.

Supplied components

• HFRR Humidity and Temperature probe

• Probe connecting cable

• Probe bracket (not required if using an HFRR Humidity Controlled Cabinet )

If the instrument is being used with a humidity controlled cabinet the probe should be located in the provided fitting on the left side of the cabinet. If the instrument is not being used with a humidity controlled cabinet, a bracket is supplied with the probe to enable the probe to be connected to the side of the mechanical unit.

HFRR Probe & Bracket

The bracket supplied is fitted to the right hand side of the instrument (when viewed from the test chamber end) using the front cover screw as shown above.

The HFRR humidity and temperature probe can be purchased separay without cable and bracket. The part code for this item is HFRHUM.

英國(guó)PCS柴油潤(rùn)滑性儀器備件

英國(guó)PCS柴油潤(rùn)滑性儀器備件