SCE238B008    SCE238B003    SCE238A007   SCE238A002   SCE238A006

ASCO电磁阀在液路系统中用来实现液路的通断或液流方向的改变，它一般具有一个可以在线圈电磁力驱动下滑动的阀芯，阀芯在不同的位置时，电磁阀的通路也就不同。阀芯的工作位置有几个，该电磁阀就叫几位电磁阀：阀体上的接口，也就是电磁阀的通路数，有几个通路口，该电磁阀就叫几通电磁阀。 电磁阀安装后，一般所有接口都应该是连接好了的，所谓工作位置指的是阀芯的位置。阀芯在线圈不通电时处在甲位置，在线圈通电时处在乙位置，阀芯在不同位置时，对各接口起到或接通或封闭的作用。

 电磁阀二位是指电磁阀的阀芯有两个不同的工作位置（开、关）。 电磁阀二通、三通指电磁阀的阀体上有两个、三个通道口； 比如二位二通电磁阀是一进一出（二个通道、zui普通常见） 二位三通电磁阀控制液体是一进二出（两出分别是一个?？桓龀１眨?；气动换向电磁阀是一进一出一排气；液压一进一出一回油。

S Junction Box
The junction box is used with spade or screw terminal
solenoids only and is provided with a grounding screw and
a 1/2I conduit connection. Connect #12---18 AWG
standard copper wire only to the screw terminals. Within
the junction box use field wire that is rated 90_C or greater
for connections. For steam service use 105_C rated wire up
to 50 psi or use 125_C rated wire above 50 psi. After
electrical hookup, replace cover gasket, cover, and screws.
Tighten screws evenly in a crisscross manner.
S DIN Plug Connector Kit No.K236--- 034
1. The open--- frame solenoid is provided with DIN
terminals to accommodate the DIN plug connector kit.
2. Remove center screw from plug connector. Using a small
screwdriver, pry terminal block from connector cover.
3. Use #12---18 AWG stranded copper wire rated at 90_C
or greater for connections. Strip wire leads back
approximay 1/4Ifor installation in socket terminals.
The use of wire---end sleeves is also recommended for
these socket terminals. Maximum length of wire---end
sleeves to be approximay 1/4I. Tinning of the ends
of the lead wires is not recommended.
4. Thread wire through gland nut, gland gasket, washer,
and connector cover.
NOTE: Connector cover may be rotated in 90_ increments
from position shown for alternate positioning of cable
entry.
5. Check DIN connector terminal block for electrical
markings. Then make electrical hookup to terminal
block according to markings on it. Snap terminal block
into connector cover and install center screw.
6. Position connector gasket on solenoid and install plug
connector. Torque center screw to 5±1 in---lbs [0,6±1,1
Nm].

二通，常闭电磁阀用于水，空气和中性气体的自动控制
采用*材料，实验证明高可靠性
zui小操作压差：0.3bar
环氧树脂浇注线圈，可以简单地从AC转换到DC